Wholesale Sigelei 20W Gravity Sensor Starter Kit with Digital Display

100% of 100
Sold Out
Out of stock

Product Overview:

The Sigelei 20W is made of pure stainless steel with an adjustable wattage from 7w to 20w. It is featured with its Gravity Sensing System, larger LED Display and venting holes for air flow.

Product Details:

The Sigelei 20W is a robust variable power device based on the SX200 chip. It can be set from 7 to 20 watts in 0.1 watt increments. The Sigelei 20W can handle an atomizer resistance range between 0.5 and 5.0 ohms. The device features a beautiful stainless steel design, an easy to read digital display, and a removable drip well for compatibility and easy cleaning. Settings are controlled via use of a built in gravity sensor system (tilting the device)

This mod is for advanced users familiar with basic ohms law and principles. All the usual safety features are built in but its important to understand the interaction of coil build to electronics capabilities & performance work together. 

The lower design limit of the board is 3V ... it's been found that the lower limit is actually a bit higher at 3.1V. What this means is if you go sub-ohm and attempt a Power setting lower than basic laws of physics would allow, that when you fire it your screen suddenly displays a higher Power output than your setting. The display is nice in this aspect ... 

For example: 

With a 0.7ohm coil on the unit set to 7W: The display then suggests an output voltage of 2.21V will be needed to achieve the 7W. Since the board in reality cannot go below 3.0-3.1V when you fire it in this example the REAL output jumps to 13W+ and the voltage goes to a REAL 3.1V. Its beyond its lower limits and fires at its real minimum capabilities given the atty resistance. This is normal and not a malfunction. 

Variable Wattage - 7W to 20W

Output Voltage - 3.0V - 8.5V

Atomizer Resistance - 0.6ohm - 3.0ohm

Spring Loaded Center Pin

510 and Ego threaded

OLED Screen

Battery Charge Indicator

Ohm Meter

Gravity Sensor System - Adjust settings by tilting the device

Short Circuit Protection

Reverse Polarity Protection

Only use a single IMR 18650 battery. This device is not compatible with protected batteries.

Low Voltage Warning

8-10 Second Cutoff Timer

Removable Beauty Ring

5 Click On/off

Dimensions: 5-1/4"L x 15/16"D

Quick Start:
1) Install Battery

2) Press the fire button 5 times and let it boot up

3) Press the fire button 5 times to enter the menu

Menu 1 - System On/Off - Tilt the unit to turn it off or on
Menu 2 - Power Setting - Tilt the unit to adjust power in 0.1W increments
Menu 3 - Exit Menu - Tilt the unit to exit the menu.

Basic Facts:

Unit: 1 set

Mod Size: 24mm*135mm

Battery Capacity: 18650mAh

Mod Material: Stainless Steel

Threading: 510/eGo

Voltage: 3.2-4.2v

Package: Paper Box

Items Contained:

1* Sigelei 20W Mechanical Mod (Assembled)

2*Rechargeable 18650 Batteries


1*18650 Battery Charger

1*User Manual

1*Gift Box


Watch video of Kanger EMUS Starter Kit

Write Your Own Review
You're reviewing:Wholesale Sigelei 20W Gravity Sensor Starter Kit with Digital Display
Your Rating

18+ / 21 +

Are you of legal age at your area to purchase vaping products?

© 2013-2020 Shenzhen AVE40 E-Commerce Co., Ltd. All Rights Reserved.