Wholesale Innokin iTaste 134 18650 VW Mod Starter Kit Come with iClear 30s Clearomizer
Available in stainless steel or black plated with stainless steel accents. Both versions have a chrome battery cap and come with an iClear 30s dual coil clearomizer tank.
The iTaste 134 offers more intuitive control and more accurate performance with its wattage scale display. Its Battery Level Indicator displays the battery capacity via green, yellow, and red LED lights. The High compatibility 510 connector fits iClear10, iClear16, and iClear30 clearomizers, as well as standard 510 accessories. The iTaste 134 is designed only for 18650 batteries. Other features of this kit include 10-Seconds Cutoff, Short Circuit Protection, Reverse Battery Protection Circuit, etc.
It has the following features:
1. Variable Wattage. You can adjust the wattage using the rotational wheel by certain increments (6.5, 8.0, 8.5, 9.0, 9.5, 10.5, 11.0, 12.0 and 12.5). The red LED will flash for six times and turn off if the rotational wheel is not in place.
2. Battery Capacity Display: the battery capacity is displayed via green, yellow and red LED light.
Green: Fully charged
Yellow: Half charged
Red: Battery low
3. Voltage Display. When a single battery is installed, different voltage is indicated by LED lights of different colors.
Green: voltage higher than 3.75V
Yellow: voltage from 3.6V to 3.75V
Red: voltage lower than 3.6V
4. Low Voltage Warning. The LED light will keep flashing in red for eight seconds when the battery capacity is lower than 3.3V and then automatically power off. The LED will stay red for five seconds if a load short circuit is detected, after which no vapor will be produced.
5. 10-second Cut-off: If the button is held down for 10 seconds or longer, the iTaste 134 will automatically power off until the button is released and pressed again.
The iTaste 134 18650 Mod also shares same features with other mods:
1. On/off Battery Switch. Press the switch three times to turn on or off the mod.
2. Short Circuit Protection (0.6+/-0.2ohm).
3. Battery Safety Protection (Vent holes).
Standby Current: 150uA maximum
Maximum Output Voltage: 6.0V (unloaded)
Maximum Output Current: 5.0A (Built-in 7A fuse for protection and stability)
Maximum Output Wattage: 12.5W (Watts mode)
The iTaste 134 Mod comes with a 510/eGo connector, and works with most clearomizers with 510/eGo threading, such as Aspire Vivi Nova BDC Clearomizer and Aspire Nautilus BDC Glass Clearomizer.
1. It suits only UNPROTECTED 18650 battery. 18350 and 18500 li-ion batteries are not allowed.
2. The mod is not detachable; the tube for 18650 battery is fixed.
3. No 18650 battery comes with the kit.
Unit: 1 Set
Material: Zinc Alloy
Size: Height 146mm; Diameter 28mm
Package: Luxury Box
1*iTaste 134 18650 Mod
1*iClear 30 Clearomizer
1*English User Manual